Ncstar MAR4S Bedienungsanleitung PDF herunterladen (Seite 2)

AR-15 QUAD RAIL HANDGUARD - RIFLE LENGTH

Item# MAR4L

 PLEASE FOLLOW ALL OF THE DIRECTIONS IN THIS MANUAL CAREFULLY.

 CAUTION: ALWAYS PRACTICE SAFE FIREARMS HANDLING!

 BE SURE THAT THE FIREARM IS UNLOADED BEFORE PERFORMING ANY OF THE FOLLOWING

PROCEDURES!

 BE SURE THAT THE FIREARM IS POINTED IN A SAFE DIRECTION AT ALL TIMES!

Installation:

Step 1

With the use of an AR-15 handguard removal tool,

pull down on the Delta Ring and remove the

handguards (See Fig. 1). If you do not have a hand

guard removal tool, then it may take two people to

remove the handguards. With one person pulling

down on the Delta Ring, have the other person

remove the handguards and set them aside.

Step 2

Take the top half of the Quad Rail, and place the beveled end inside the Delta Ring, while making

sure that the Gas Tube Channel inside the Quad Rail lines up with the rifle’s gas tube (See Fig. 2).

Next, while holding the top half of the Quad Rail, press down towards the Delta Ring. It may be

necessary to apply a fair amount of pressure in order to get the Quad Rail to fit around the barrel

nut. While holding the Delta Ring down, lower the top half of the Quad Rail into place, making sure

to insert the small tabs on the front end of the Quad Rail into the Handguard Cap (See Fig. 3).

Release pressure on the Delta Ring, and allow the top half of the Quad Rail to set in place (See Fig

5).

1 2 3 4

Keine Kommentare

Ncstar MAR4S Bedienungsanleitung Seite 2